Product Categories
Zhangjiagang City Zhangyun Machinery Manufacturing Co.,LtdAdd:Xindong Road, Daxin Town, Zhangjiagang City, Jiangsu Province, China
Tel:+86-512-58376558
Fax:+86-512-58376989
Ph:+8613584478980
E-mail:yvonnechan@zyjxzz.com
Roof Panel Roll Forming Machine

Roof Panel Roll Forming Machine
1. Technical Requirements:
1.1 Equipment technical conditions
Equipment Floor Area: 18*1.5*1.5m (L*W*H)
Feeding Direction: From Right to Left
Voltage: 3 phase, 380V, 50Hz
Flow Rate: 0.5m³/min; Pressure: 0.6MPa
1.2 Main technical parameters
Width of Strip ≤1200mm
Thickness of Strip ≤ 1.2 mm
Strip strength:≤360
Total Power: approximately 15KW
2. Process
Uncoiling →Rolling Forming→ punching cut Machine
2.1 De-coiler
Width of coil: Max1500mm
Inner Diameter of Coil: 500mm
The range of inner diameter: ф490-520 mm
Outer Diameter of Coil: φ1300mm
Load Capacity: ≤5T
Expansion Model: Hydraumatic
2.2 Forming: high precision wallboard support, gear chain drive (variable frequency motor control)
2.3 Cutting length precision: ±3mm
2.4 Electric Control System
There are two modes of operation: manual and automatic. With manual and automatic switching function: in the manual state, can stand-alone operation, easy maintenance; in the automatic state, the full range of production run, the order to start; full line with emergency stop button, easy to deal with emergencies, to ensure that equipment and operators safety.
There is a manual operation panel next to the operator to facilitate the operation of the workers.
The corrugated color steel plate produced by this roof panel roll forming machine has wide coverage area and good waterproof effect and is widely used in construction appliances and transportation industries.
Features:
1. Low noise and high production efficiency.
2. It can not only manufacture single-laminated panels, but also can produce ordinary I-shaped aluminum composite panels, tongue-and-groove composite panels, and a multi-purpose machine.
3. The host uses advanced frequency control, automatic fixed length cutting.